Check the angle with a magnetic digital angle finder (see Tip) or a protractor and bevel gauge. Tilt the table-saw blade to a 60-degree angle. Then use a track saw (or a circular saw guided by a straightedge) to rip one edge of each board straight and square. If you lack access to a surface planer, some hardwood lumber suppliers will plane the boards for you, for an extra charge. Run the boards through a thickness planer to flatten and smooth each face, and make them the same thickness: between 1 1⁄4 and 1 3⁄8 inches.

Steps for building a 3D cube cutting board # Step 1: Plane the boards to a uniform thickness # Tom had such a good time making this one, he went ahead and made two of them: one for his son and one for his daughter. As with any board in which the grain runs vertically, “a knife does less damage to the wood than on a flat-grain board,” Tom says.Ĭutting boards make great gifts. When assembled into a board, they fool the eye into seeing three dimensions. Tom and Kevin cut and glued together wood strips into identical rhombus shapes, then sliced them into six-sided pucks. It is a gift for my daughter.Three woods of contrasting colors give the board its intriguing appearance: maple, oak, and cherry sourced from a hardwood lumber dealer. I have glue and plenty of clamps and am not really in a panic to finish, but would like to complete this project in less than a century, preferably by mid-March. I need a reasonably simple but sure approach to fitting all these &^%!** hexagons together without gaps. I am at the point where I have cut and glued the diamond shapes into hexagons and now I am facing the task of gluing the hexagons together to make the board, but I need some suggestions because, the wood, being imperfect, and me, being more-so, resulted in hexagons that are not perfect.

My stop slipped during the process of cutting the diamonds and I had to create a jig to hold each small diamond and process each one a second time in order to get them all to be identical. I have the DOUBLE DUBBY from In-Line Industries and used his example of cutting multiple segments for bowl, but by not flipping the stock after each cut, the result is a diamond not a wedge. I have watched the video at least 3x thru and until today, thought I understood the process fairly well.Ĭutting all the diamond shapes turned out to be not quite as simple as the video shows.

3d cube end grain cutting board plans